Loading ...
Loading ...
Loading ...
Fig, 1
Setting Surface Controls
Fig. 2
Fig. 3
Fig. 4
OPERAT(NGTHE DUAL SURFACERAD(ANTELEMENT
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
,
5.
6.
,
,
Both the 30" and 36" cooktops are equipped with dual radiant surface element
located as shown in Figs. 1 & 2. A touch key pad on the element controls is used
to select one of the 2 positions of the element. Symbols and indicator lights on
the control panel are used to indicate which coil of the dual radiant element will
heat. The e symbol indicates that only the INNER coil will heat (Fig, 3). The ®
symbol indicates that both INNER and OUTER coils will heat (Fig, 4). You may
switch from either coil setting at any time during cooking.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the radiant surface element,
2. Touch and hold the (_ key pad until a beep sound, The power
POV_R
indicator light above the (_ will turn ON. Note: If no other key pad is
POWER
touched within 20 seconds the request to Power ON the cooktop will
clear,
3. Touch and hold the C) pad for the dual element position until a beep
QvO_f
is heard, The display will show" =="
Note: If no further pads are touched within 10 seconds the request
to power the element ON will clear,
oO
Select the INNER (Fig, 3) or INNER and OUTER (Fig, 5) to heat by touching the 0 key
pad.
Touch _ pad once to turn ON the power level to HL Touch _ pad once for Lo.
Each touch of the _ or _ pad will decrease or increase the power level from 9.0
through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.0 will decrease
or increase by .2 increments, Lo is the lowest power level available,
Note: The power level may be adjusted at any time while the element is ON.
Start most cooking operations on a higher setting and then turn to a lower setting to finish
cooking, Each surface element provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface heating area,
When cooking has been completed touch the .(_, pad once to turn the element 0 FF and
if no other surface element is used touch the (_) key pad to turn off the cooktop.
POWER
Note: The HE message will appear in the display after turning the control knob to OFF if
the cooktop is still hot and remain on until the heating surface area has cooled
sufficiently.
Loading ...
Loading ...
Loading ...