Loading ...
Loading ...
Loading ...
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
37
5. PANEL MOUNTING
EN
5.11 Mounting panels to the door
Once all brackets and small brackets
have been applied to the panels, you can
begin installing the bottom drawer.
> Hook the panel to the fixing devices starting
from the top aligning brackets [ 6 ].
> At this point, alignment between the panel
and adjacent cabinets can be adjusted using the
alignment brackets and small brackets [ 7 ] and
[ 8 ].
> Vertical alignment: tighten or loosen the screw
in the brackets to raise or lower the panel [ 9 ].
> Depth alignment: working from the inside of
the door, after lifting up the magnetic seal on
the handle side and rotating the plastic covers
on the hinge side, adjust the panel position in
the Z-direction by adjusting the shoulder bolts
and setscrews with the 4-mm Allen wrench in
combination with each other and finally locking
each mounting position in place
[10 & 11].
Once the front panel has been adjusted,
check that the gasket has been repositioned
correctly to ensure that the door/drawer is
closing correctly and to avoid operational
errors in the unit.
The product handle is not included in the appliance
packaging but must be purchased separately.
For handle installation, please refer to the
instructions included in handle packaging.
5.12 Mounting panels to the drawer
Once all brackets and handles have been
applied to the panels, you can begin in-
stalling the bottom drawer.
Proceed as follows:
> Partially tighten the screw to the nut in the ap-
pliance drawer [ 1 ].
7
8
6
10
11
9
1
Loading ...
Loading ...
Loading ...