Loading ...
Loading ...
Loading ...
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
22
3.1 Transport to installation site and
unpacking
The appliance is very heavy.
Exercise maximum caution during
handling to avoid injury.
The appliance should always be
transported in an upright position.
Avoid leaning it on its front side at all
costs.
As this appliance is large and heavy, check the
access to the site where it will be installed (door
size, maneuvering space in stairwells, etc.) before
transporting the appliance.
The appliance is attached to the base of the packaging
(pallet) by four bolts which can be removed using a
19-mm (3/4”) wrench.
We recommend using a manual transportation device
to move the appliance to the installation site, and only
removing the base of the packaging at this point.
The appliance should always be transported in an
upright position.
If this is not possible, transport the appliance lying on
its rear side. Once at the installation site, the appliance,
which is equipped with four wheels, can be taken o
the pallet and positioned in the installation area.
Proceed as follows:
> Remove the four bolts securing [ 1 ] the appliance
to the pallet by means of a 19-mm (3/4”) wrench or
socket.
> Remove the fixing brackets [ 3 ] and [ 4 ].
> To release the front fixing bracket [ 3 ], loosen the
rear wheel adjusting bolt [ 2 ] using a 13-mm (1/2”)
wrench or socket. Avoid straining this bolt one way
or the other at its stop points so as to avoid damaging
the rear leveling system.
Ensure that the front leveling legs are retracted, so
that all four wheels are able to contact the floor for
easiest maneuvering.
>
Remove the appliance and place it on the floor using a
suitable, heavy-duty hand truck from the back of the unit.
3. PREPARING FOR THE INSTALLATION
Be very careful to avoid any damage to floors. Delicate
floors should be protected with plywood, heavy
cardboard or panels of similar material.
> At this point, adjust the rear rollers down (clockwise
on the leveling rod [ 2 ]) until they make contact with
the floor, and raise the rear of the appliance enough so
that it will roll freely
3.2 Electrical and water connection
The Built-in filter cannot make any water
which is not already suitable for human
consumption safe to drink.
The appliance should be connected only
to a potable water supply system.
Do not use extension cords or adapters.
In the event that the water supply must be
turned o after the appliance has been fully
installed and connected to the water supply
(if applicable), and is operational, disable
the ice maker before the main water supply
is shut o to prevent the appliance from
entering a ‘NO WATER IN’ alarm state. Refer
to the Use & Care Manual for instructions
on disabling the ice maker.
Electrical or water connections located
directly behind the appliance must be
recessed. Do not put the water shut-off
valve directly behind the appliance.
It should be in an accessible location.
E
E
E
E
E
W
W
W
W
W
E
W
• OVERHEAD VIEW •
EW
EW
1
4
1
2
3
ELECTICAL & WATER
CONNECTION
Loading ...
Loading ...
Loading ...