Loading ...
Loading ...
Loading ...
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
24
3. PREPARING FOR THE INSTALLATION
TOP COMPRESSOR UNIT:
Proceed as follows:
> Unwind the electric cable, and connect it directly to
the wall socket.
> Make sure the appliance is in Stand-by mode and
that all lights are o; if not, press the Unit button
to switch it o.
> Firmly tighten with fingers. A tool/wrench should
not be needed to create a proper seal with the rubber
washer in the adapter. Turn the water on, and ensure
that no connections are leaking prior to pushing the
unit into the opening.
3.4 Leveling
Adjust the appliance level by means of the front
levelling feet [ 1 ] and the adjustable rear wheels
[ 2 ].
.
fig.3 Front of appliance
fig.2 Back of appliance
Proceed as follows:
> If necessary, remove the bottom plinth or grille
(it is kept in position by magnets), and adjust the
height of the leveling feet
[ 1 ] using a 17-mm
(11/16”) wrench.
> Then, adjust the height of the rear wheels by
turning the front adjusting bolts [ 2 ] clockwise
(raise) or counter-clockwise as required.
Exercise caution if using a power driver for this,
and lower the clutch to prevent damaging the
leveling mechanism.
> Remount the bottom plinth or grille.
> If you have accidentally backed out the leveling
rod so that it is disengaged from the leveling
mechanism, you will need to pull the appliance
forward to access the rear of the base; locate
the locking nut, which will be loose under the
appliance, and re-thread the rod through the
leveling plate of the mechanism; then, reinstall
the locking nut and attempt to level the appliance
again.
1
Electrical connection
Water connection
1
2
1
2
Loading ...
Loading ...
Loading ...