Loading ...
Loading ...
Loading ...
Special InstallationInstructionsforAustralia and New Zealand.
Installingthe WaterLine(continued)
Turn the Water On
Tm'n the water On at the shutoiI valve.
Tighten any connection that leaks.
Replace the access cover and tighten all screws
(on some models).
Plug In the Refrigerator
Plug in the refrigerator to the Power (-)utlet and
tm'n On.
IMPORTANP. Always operate the Refligerator fl'om
a power source of the same Voltage, Frequency
and Rating as indicated on the Refrigerator
Identification Plate. Operate the Refrigerator
from an Earthed (Grounded) 3 Pin Power Outlet
fiflly accessible when the refrigerator is located
in its nomml operating position.
Arrange the coil of robing so that it does not
vibrate against tile back of tile refl'igerator or
against the wall,
Push tile refl'igerator back to tile wall, making sure
tile power cord and tile water line tubing are not
trapped, entangled or squashed by the refl'igerator
(including tile wheels) or wall.
Start the Icemaker
Set tile icemaker power switch to tile I position.
Tile icemaker will not begin to operate/mtil it
reaches its operating temperature of-9°C or below.
It will then begin operation automatically if tile
icemaker power switch is in the I position.
NOTE:In lower water pressure conditions, tile
water valve Ill}IV tHI'n on tl I) 1o .'4 tillles to make s/iYe
enough water reaches tile icemaker.
switch_
24
Loading ...
Loading ...
Loading ...