Loading ...
Loading ...
Loading ...
6
Downrod
Canopy
Yoke Cover
Yoke
Tab
Slot
Downrod
Mounting
Bracket
ASSEMBLY INSTRUCTIONS
7
6
5
5. Insert the downrod through the canopy and yoke cover.
Feed the wires from the fan through the downrod.
6. Slide the downrod into the yoke of the motor assembly,
align the holes, then re-install the downrod pin and
downrod clip. Secure with the two set screws and slide the
yoke cover down until it rests on top of the
motor assembly.
Note: With wiring extending out of the downrod, measure
8 inches of lead wire and cut the excess wire with wire
cutters (not included). Then strip 1/2” of insulation from
the end of each wire.
Downrod Pin
Yoke
Downrod
Downrod Clip
Yoke Cover
Set Screw
7. Lift the downrod into the mounting bracket. Rotate the
downrod until the tab in the mounting bracket is seated
in the slot in the downrod ball.
WARNING: The fan and/or downrod should not rotate in
the mounting bracket if installed correctly. Failure to align
the slot in the downrod ball with the tab in the mounting
bracket may result in fan falling causing serious injury or
death.
8. Insert the receiver, antenna rst, into the mounting
bracket with the at side facing the ceiling.
Note: The receiver will rest directly on top of the
downrod.
Mounting Bracket
Receiver
8
Loading ...
Loading ...
Loading ...