Loading ...
Loading ...
Loading ...
Installer Manual 6
5
INSTALLER SETTINGS
The Installer Settings must be properly configured in order for this thermostat to operate correctly. The Installer
Settings are menu driven. The portion of these settings that do not apply to your setup will be skipped.
To Enter Installer Settings Menu
1
Press and hold down the MENU button for 5 seconds.
2 Release the MENU button after the first installer
setting is displayed.
3
Change settings as required using the or buttons.
4 Press MENU to move to the next setting.
5 Menu will exit automatically after last setting.
*If 0000 IL is displayed, you must enter your 4-digit
installer lock code to proceed (see Installer Settings
9 and 10).
No.
Installer Setting Displayed Default
Available
Description of
Setting
Settings
Available Settings
1 Temperature Scale DEG F
Selects a temperature scale of either °F or °C.
2 1st Stage Differential DIF1 0.5
Selects a 1st stage temperature differential which controls the degree of separation between the setpoint temperature
and the 1st stage of heating or cooling.
3 2nd Stage Differential DIF2 2.0
[1230 only] Selects a 2nd stage temperature differential which controls the degree of separation between the 1st
and 2nd stage of heating or cooling.
4 Compressor Short Cycle
CSCP 5
Protection (CSCP)
Selects the number of minutes the compressor will be locked out after turning off. This delay will run simultaneously with
any delay built into the equipment.
5
Heat Setpoint
HIGH HEAT 90
Upper Limit
Selects the upper setpoint adjustment limit that cannot be exceeded in heat mode.
6 Heat Setpoint
LOW HEAT 45
Lower Limit
Selects the lower setpoint adjustment limit that cannot be exceeded in heat mode.
7 Cool Setpoint
LOW COOL 45
Lower Limit
Selects the lower setpoint adjustment limit that cannot be exceeded in cool mode.
F Select for Fahrenheit temperature display
C Select for Celsius temperature display
0.5, 1.0, 2.0
Select a 1st stage temperature differential of
0.5°, 1° or 2° F (0.2°, 0.5° or 1.0° C)
1.0, 2.0, 3.0
Select a 2nd stage temperature differential of
4.0, 5.0, 6.0
1°, 2°, 3°, 4°, 5° or 6° F (0.5°, 1.0°, 1.5°, 2.0°,
2.5° or 3.0° C)
5, 4, 3,
Select CSCP delay duration in minutes
2, 1, 0
90 - 45 Select a Heat Setpoint Upper Limit of 90° to
(32˚ to 7˚C) 45°F (32° to 7°C)
45 - 90 Select a Heat Setpoint Lower Limit of 45° to
(7˚ to 32˚C) 90°F (7° to 32°C)
45 - 90 Select a Cool Setpoint Lower Limit of 45° to
(7˚ to 32˚C) 90°F (7° to 32°C)
Loading ...
Loading ...