Loading ...
Loading ...
3 Installer Manual
Provide Power
• Battery Power - Insert the 2 supplied “AA” type alkaline batteries into the battery compartment located
in the rear housing of the thermostat. Make sure to position the Positive (+) and Negative (-) sides of the
batteries correctly with the +/- symbols in the battery compartment.
• Optional 24 Volt AC power - Connect the common side of the transformer to the C terminal on the
thermostat sub-base. In dual transformer installations, the transformer common must come from the
cooling transformer.
C
24VAC Power Terminal (C)
Batteries Installed as Shown
2
INSTALLATION
Factory Setting
Switch Default Options Comments
CONV / HP CONV
HG / HE HG
Set Installer Switches
CONV Select for conventional systems
HP Select for heat pump systems
HG Select for gas heat
HE Select for electric heat
The Installer switches are located on the back of the thermostat and must be
properly configured for this thermostat to operate properly.
Attach to Thermostat Sub-Base
UP
UP
Once you complete the wiring in Section 3, attach
thermostat to sub-base and then configure the
Installer Settings in Section 5.
1) Line up the thermostat body with the sub-base.
2) Carefully push the thermostat body against the
sub-base until it snaps in place.
NOTE: This thermostat ships configured as a
conventional (CONV) thermostat.
Loading ...
Loading ...
Loading ...