Tripp Lite SRCABLELADDER Owner's Manual

Loading ...

Note: Follow the instructions in this section only if the SRCABLELADDER accessory will be installed within a row of enclosures. If the

SRCABLELADDER accessory will be installed across an aisle, follow the instructions in Section 3-4 Installation Across Aisle instead.

3-5 Installation Within Row

Insertfourassemblybrackets

in the open ends of the ladder,

hookedendrst.Whentheladderisorientedsothattheladder’s

rungs are above the ladder’s side rails, the hooked ends of the

brackets should point down, as shown in the drawing.

Align the pin holes in the ladder sections with the pin holes

in the assembly brackets and insert clevis pins

into the pin

holes(4total).Thisstepmaybeomittedtoprovideadditional

installationexibility,butinstallingthepinswillmakethe

SRCABLELADDER accessory more stable. Warning: If you

choose not to install the clevis pins, make sure at least 25% of

the length of each assembly bracket is inside the ladder.

After inserting the clevis pins, insert a cotter pin

through the

holeattheendofeachclevispin.(Thestraightsectionofthe

cotterpingoesthroughthehole.)

Usinganassistant,lifttheSRCABLELADDERaccessory(rungs

upward)andaligntheholesattheendsoftheassemblybrackets

with the corresponding holes

in the SRCABLETRAY

accessories installed at the top of each enclosure. Note: There are

two levels of holes. Use the holes that match your application best.

Align the pin holes and insert clevis pins

into each of the pin

holes(4total).

3 – Installation (continued)

201105211 93-2973.indb 6 5/23/2011 12:56:47 PM

Loading ...

Tripp Lite SRCABLELADDER SmartRack 10-ft. x 1-ft. (3 m x 0.3 m) Cable Ladder