Tripp Lite SRCABLELADDER Owner's Manual

Loading ...

Note: Follow the instructions in this section only if the SRCABLELADDER accessory will be installed across an aisle. If the SRCABLELADDER

accessory will be installed within a row of enclosures, follow the instructions in Section 3-5 Installation Within Row instead.

3-4 Installation Across Aisle

Insertfourassemblybrackets

into the ends of the ladder. The

hookedendsofthebracketsshouldbeexposed.Whentheladderis

oriented so that the ladder’s rungs are above the ladder’s side rails,

the hooked ends of the brackets should point down, as shown in

the drawing.

Align the pin holes in the ladder sections with the pin holes

in the assembly brackets and insert clevis pins

into the pin

holes(4total).Thisstepmaybeomittedtoprovideadditional

installationexibility,butinstallingthepinswillmakethe

SRCABLELADDER accessory more stable. Warning: If you

choose not to install the clevis pins, make sure at least 25% of

the length of each assembly bracket is inside the ladder.

After inserting the clevis pins, insert a cotter pin

through the

holeattheendofeachclevispin.(Thestraightsectionofthe

cotterpingoesthroughthehole.)

Usinganassistant,lifttheSRCABLELADDERaccessory

(rungsupward)andinserttheexposedhookendsofthe

assembly brackets

into the corresponding slots

in the

SRCABLETRAY accessories installed at the top of each

enclosure.Thehooksshouldttheslotssecurelybyslidingdown

to engage the edge of the slot. Note: There are two levels of slots.

Use the slots that match your application best.

3 – Installation (continued)

201105211 93-2973.indb 5 5/23/2011 12:56:46 PM

Loading ...

Tripp Lite SRCABLELADDER SmartRack 10-ft. x 1-ft. (3 m x 0.3 m) Cable Ladder