Loading ...
Loading ...
Loading ...
HOLE LOCATOON
Make a DENT in the workpiece where you want the hole
. . . using a CENTER PUNCH or a SHARP NAIL.
Before turning the switch ON, bring the drill down to the
workpiece lining it up with the hole location.
FEEDONG
Pull down on the feed handles with only enough effort to
allow the drill to cut.
Feeding TOO SLOWLY might cause the drill to burn ,.
Feeding TOO RAPIDLY might stop the motor ,.. cause
the belt or drill to SLIP ... tear the workpiece LOOSE
from your hand or BREAK the drill bit.
When drilling metal use Sears Thread-cutting oil
adiustments
WARNING: FOR YOUR OWN SAFETY TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAKBNG ANY ADJUSTMENTS,
DEPTH SCALE
When the quill is in the UPPERMOST position, the top
SURFACE OF THE FEED STOP POINTER should be in
line with "'0"" graduation on the DEPTH SCALE.
If it is not ... LOOSEN both mounting screws and
reposition the scale.
FEED STOP ~
POINTER
MOU NTIN
SCREWS
QUILL RETURN SPRING
If the quill does not return to its UPPERMOST position
when the quill lock is UNLOCKED .,. or if the return
action is SLUGGISH ... the SPRING TENSION must be
increased.
1. Move DEPTH POINTER to uppermost position and
2.
3.
4.
5,
lock it in place.
Lock the quill in the uppermost position.
GRASP the HUB . .. pull it straight out until it is free
to turn.
BARREL LOCK
Rotate hub COUNTERCLOCKWISE about 1/4 turn
and PUSH it back in place. This wilt WIND UP the
spring.
Unlock quill ... check tension ... if more is required,
repeat steps 2, 3, 4, and 5.
TABLE AND HEAD LOCK HANDLES
RETURN SPRING
TABLE LOCK HANDLE
The lock handles can be adjusted to make them more
convenient to operate.
1. Make sure the support collar is locked in position below
the table or the head.
2. Unscrew the lock handle and push the barrel lock out
of the hole,
3. Rotate the barrel lock 180 ° , replace it in the hole and
screw in the handle.
NOTE: The HEADLOCK HANDLE is located on the LEFT
side of the head.
BELT TENSION
Refer to section "Getting To Know Your Drill Press" ,,.
BELT TENSIONING ROD.
HANDLE
_7
Loading ...
Loading ...
Loading ...