Loading ...
Loading ...
Loading ...
- 7 -
STEP 1: Wheel Assembly
1.
Attach the wheel (#35) to the oil tank axle (#44) using a conical roller bearing (#81), flat washer
Ø20 (#70) and tighten the wheel with the hex slotted nut M20 (#37). Lock the hex slotted nut
M20 (#37) in place using the cotter pin Ø4x36 (#73). Install the axle cap (#41) on the end using
rubber hammer.
Note: flat washer Ø20 (#70), hex slotted nut M20 (#37) and cotter pin Ø4x36 (#73) are already
on reservoir axle (#44), need take out then to assemble. Make sure bearings (#81) and oil
seal (#80) assembled inside of the wheel (#35). After tightening the slotted nut, loosen nut
1/4 of a turn so the tire will rotate freely. Failure to loosen the nut may cause excessive
bearing and tire wear.
STEP
2: Attach Tow Bar to the Hydraulic Tank
1.
Attach the tow bar (#59) to the hydraulic tank and secure using two hex bolt M12x100 (#24),
flat washer Ø12 (#62) and nylon lock nut M12 (#13).
Assembly Instructions
Tips: Use a black plastic bushing to fix the axle
cap (#41), cover the black bushing on the axle cap,
then use a rubber / wooden hammer to knock the
end of the plastic bushing and attach the axle cap
onto the wheel.
Loading ...
Loading ...
Loading ...