Jump-N-Carry JNC1224 JNC1224 Operator's Manual

Loading ...

FEATURES

• TheJump-N-Carry provides plenty of power for starting vehicles – more than

enough to start most cars, light trucks, watercraft, implements and more.

• TheJump-N-Carry will power most 12 Vdc accessories equipped with a male

12 Volt plug. The DC outlet features automatic overload protection.

• Theunitfeaturesatestswitchandbatterystatusgauge,whichprovidesan

approximate indication of the battery’s state of charge.

• TheJump-N-Carry features convenient side-mounted holsters with cable tracks

for easy cable and clamp management. Always re-wrap cables and re-holster the

clamps after each use.

• TheJump-N-Carry contains the latest technology with its twin sealed,

non-spillable battery and may be stored in any position.

RECHARGING

Note: Upon initial purchase, charge your Jump-N-Carry for a minimum of 24 hours.

VERIFYTHEFOLLOWINGPRIORTOCHARGING:

- Two pin connector and cable are not damaged.

- The voltage selector is disconnected and all connectors are in good working order.

- Clamps, jaws, and cables are in their proper storage location.

There are two ways to charge your Jump-N-Carry.

The recommended method is recharging using AC

power, where the provided 2-pin extension cord

is connected to the built-in charger. An alternative

method is through the DC power outlet using the

provided12VoltMale-MaleExtensionCord.When

the DC (12V) charging method is used, care must

be taken not to overcharge the Jump-N-Carry, as

noted.

Charging using the built-in charger (recommended

method). Withthismethod,theprovided2-pin

extension cord is connected to the Jump-N-Carry

through the built-in charger located on the front of

theunit.Onlyusetheprovidedextensioncordwhen

charging the unit.

BATTERY STATUS GAUGE

Press the red switch to momentarily activate the battery status gauge. The gauge is an

approximateindicatorofthebattery’sstateofcharge.Whenfullychargedinthe12-volt

mode and disconnected from charging power, the gauge should read from 13-13.5 Volts.

WARNING

Explosion risk! Never charge a unit that was exposed to mismatched voltage (set to

12V but connected to a 24V system). Such units should be taken out of service and

have the batteries replaced prior to further use (see Jump Starting Instructions).

Loading ...

Jump-N-Carry JNC1224 3400 Peak Amp 12/24V Jump Starter