Jump-N-Carry JNC1224 JNC1224 Operator's Manual

Loading ...

STORAGE

The Jump-N-Carry may be stored virtually anywhere, and in any position. It is best to

ensure that it is stored in a safe, secure location that is not exposed to temperature

extremes. Please remember to charge it every 90 days when not in use, but more

frequently if it is stored in very cold (<40°F) or very hot (>90°F) conditions.

Take precautions to ensure that the positive and negative clamps do not come into

contact with each other or a common metal surface. In addition, during storage,

disconnectthevoltageselector,renderingtheunitOFF.Werecommendstoringthe

Jump-N-Carry in the box in which it was originally received. Always be sure to re-wrap

cables and re-holster clamps after each use and prior to storage.

TESTING THE BATTERY

After fully charging the battery (see “Recharging” section), with the unit connected in

12V mode, apply a 100 amp load to the unit for a period of 6 seconds, while monitoring

the battery voltage. The battery is good if the voltage is 9.5 Vdc or higher.

The battery inside this product is a sealed lead-acid battery. It is required by law to

beremovedandrecycledordisposedofproperly.Whiletherearefederalregulations

thatmustbecompliedwiththroughouttheUnitedStates,yourindividualstateorlocal

governments may have additional regulations to be followed.

Whenthebatteryinthisproductisinneedofreplacement,removeitaccordingtothe

instructions provided below and take it to your local recycling center for proper recycling

or disposal. If you don’t have a local recycling center that handles sealed lead-acid

batteries, contact your local environmental agency for instructions.

Removal instructions:

Beginbymakingsurethatbothclampsaresecurelyplacedinapositionthatensures

they will not come into contact with each other.

1. LaytheJump-N-Carrydownonitsfront.Onthebackoftheunit,locatethe8

screws that join the back plate to the case.

2. Remove the screws, then lift off the back plate.

3.Onthetopofthebatteryaretwoterminals,eachwithwiresconnectedtothem.

Disconnect these wires from the battery by removing the bolts that hold them to

the battery terminals. To prevent accidental arcing, be careful not to touch both

battery terminals with the tools being used to remove the bolts.

4.Liftthebatteryoutofthecase.

BATTERY REPLACEMENT AND DISPOSAL

This unit contains a sealed non-spillable lead-acid battery.

This battery must be recycled. Consult your state or local

government concerning regulations for proper disposal.

Loading ...

Jump-N-Carry JNC1224 3400 Peak Amp 12/24V Jump Starter