Tripp Lite B162-100-POE Owner's Manual

Loading ...

11.3 Executing Commands

The following instructions presume command operations using a PC. To execute a command, do the following:

1. On a connected PC, open a command prompt as administrator.

2. Depending on the supported command type for your PC, do the following to connect to your deployment:

• Telnet connections - In the command prompt, type the IP address of any B162-100-POE receiver in your

setup and use port 23. For example:

• TCP connections - In the command prompt, type the IP address of any B162-100-POE receiver in your

setup and use port 9138. For example:

• RS-232 connections - In the DVOE Manager, set the IR/RS-232 of all B162-100-POE receivers to Manual

and select the Command Mode option.

3. When the connection is established, the message “Welcome to CLI mode” appears.

4. Type the command you wish to execute. For information on command syntax, see Commands.

5. Press Enter to execute the command.

6. When the command is successfully executed, the system returns a conﬁrmation message.

7. To end the session, type logout in the command prompt and press Enter.

11. CLI Commands

Loading ...

Tripp Lite B162-100-POE HDMI over IP Decoder - 4K, 444, PoE, 328 ft. 100 m