Loading ...
Loading ...
Loading ...
ASSEMBLY
The major components of this chipper/shredder have been
assembled at the factory. Some minor assembly is required. The
assembly process will use all the parts and hardware listed in the
package contents.
DO NOT attempt to start this machine until all assembly has been
completed. Serious personal injury and damage to the machine could
occur.
(a) Tip the chipper/shredder over and remove the bolts shown in.
NOTE: DO NOT turn the chipper/shredder over once it is full of oil and
fuel. The oil and petrol will spill out.
Fixing the leg: x2 Bolt M8x20, x1 Bolt M8x200, x1 Support Tube, x4
Washer Ø8, 3pcs Lock Nut M8.
Fixing the wheel assembly: x2 Bolt M8x200, x2 Support Tube, x4
Washer Ø8, x2 Lock Nut M8.
(b) Attach the wheel assembly and the leg with the bolts that were
removed in step (a).
(c) Place the handle on the hopper and line up all of the holes.
Secure it with flat washer (Ø8, 4pcs), spring washer (Ø8, 4pcs)
and bolt (M8x20, 4pcs).
(d) Place the funnel over the studs in the side of the chipper/shredder
and secure it with flat washer (Ø8, 3pcs), spring washer (Ø8, 3pcs)
and locknut (M8, 3pcs).
NOTE: Before operating, fill the engine with oil and petrol.
7
Loading ...
Loading ...
Loading ...