Loading ...
Loading ...
Loading ...
BELT
Replace or tighten the v-belt if you notice the motor running and the
chipper blades are not spinning.
TURN OFF THE MACHINE, ALLOW ALL MOVING PARTS TO
COME TO A COMPLETE STOP, AND DISCONNECT THE SPARK
PLUG WIRE
Remove the v-belt cover as shown in.
Roll the belt off of the pulleys and install the new belt.
Replace the v-belt cover and re-attach the spark plug wire.
STORAGE
Follow these guidelines when storing your chipper/shredder.
Remove the spark plug wire to prevent unauthorized starting.
Place the chipper/shredder in a dry, level area. If the chipper/shredder
is tipped it may leak oil and petrol.
DO NOT store the chipper/shredder near an ignition source, such as
a wood stove, gas or electric heater, or an appliance or heater with a
pilot light.
Store the chipper/shredder in a well ventilated area. DO NOT store the
chipper/shredder in an area that will allow toxic gas fumes into areas
inhabited by humans or animals.
Close the discharge chute deflector and place the covers over the
hopper and the funnel to prevent objects or critters from getting into
the machine.
If the engine is not to be used or is to be stored for more than one
month the following storage procedure should be carried out. Drain all
the fuel from the fuel tank and the carburetor ensure that all the fuel
has been removed. Remove the spark plug and pour approximately
one tablespoon full of clean engine oil into the spark plug hole. With
the ignition turned OFF gently pull on the recoil starter cord several
times. Re-fit the spark plug continue to pull the recoil starter cord until
the piston is on the compression stroke (when resistance is felt) then
stop pulling.
15
Loading ...
Loading ...
Loading ...