Loading ...
Loading ...
Loading ...
Problem Cause
There is vibration in the product The collector is full. The operator has ignored the collector full signal or the sen-
sor for collector full is set in the incorrect position. See
To adjust the sensor for
collector full on page 16
.
The product is operated in long, thick and/or wet grass in non-collect mode. See
To get a good mowing result on page 18
.
The blades are loose. See
To examine the blades on page 28
.
One or more of the blades are unbalanced. See
To examine the blades on page
28
.
The auger is damaged.
The engine is loose.
The mowing result is unsatisfac-
tory
The blades are blunt. See
To replace the blades on page 28
.
The grass is long or wet. See
To get a good mowing result on page 18
.
The cutting deck is skew.
There is grass blockage in the cutting deck. See
To clean the product on page
20
.
The tire pressure is different on the right and left sides. See
To set the tire pres-
sure on page 25
.
The product is operated at a too high speed. See
To get a good mowing result
on page 18
.
The engine speed is too low. See
To get a good mowing result on page 18
.
The drive belt slips.
Transportation, storage and disposal
Transportation
•
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1.
Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission when you tow. See
To
engage and disengage the drive system on page 15
.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If you
keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
32 368 - 004 -
Loading ...
Loading ...
Loading ...