Loading ...
Loading ...
Loading ...
Problem Cause
The starter motor does not turn
the engine over
The parking brake is not applied. See
Safety circuit on page 9
.
The lift lever for the cutting deck is in mowing position. See
Safety circuit on
page 9
.
The main fuse is blown. See
To replace a fuse on page 24
.
The ignition lock is defective.
The connection between the cable and the battery is bad. See
Battery safety on
page 11
.
The battery is too weak. See
To charge the battery on page 24
.
The starter motor is defective.
The engine does not start when
the start motor turns the engine
over
There is no fuel in the fuel tank. See
To fill fuel on page 14
.
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The engine does not run smooth-
ly
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
To clean and change the air filter on page 24
.
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The engine apparently has no
power
The air filter is clogged. See
To clean and change the air filter on page 24
.
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission does not have
sufficient power
The transmission cooling air intake or the cooling flanges are blocked.
The fan on the transmission is damaged.
The hydraulic oil cooling fan (RC 320Ts AWD only) is blocked. See
To clean the
hydraulic oil cooler on page 21
.
The hydraulic oil cooling fan (RC 320Ts AWD only) is damaged.
There is no oil in the transmission or the oil level is too low. See
To do a check
of the transmission oil level on page 30
.
The battery does not charge The battery is defective. See
Battery safety on page 11
.
The connection at the cable connectors on the battery terminals is bad. See
Bat-
tery safety on page 11
.
The battery is in protective mode. See
To charge the battery on page 24
.
368 - 004 - 31
Loading ...
Loading ...
Loading ...