Loading ...
Loading ...
Loading ...
5. HEALTH AND SAFETY INFORMATION
− The safety button on the gun is not there to lock the lever during operation, but to prevent its
accidental operation.
− Appliances equipped with Total Stop System: these appliances should not be left in standby for
more than 5 minutes.
− Switch the appliance off completely (master switch ON/OFF) whenever it is left unattended.
− Take care not to damage the electric cable. Have a damaged power cord replaced immediately
by an authorized service point or an electrical specialist.
− The high pressure hose is designed and produced to withstand high pressures. To avoid
damage, it must be handled with special care. Misuse may lead to premature breakages or
damage and cause the loss of warranty cover.
− Never start the high-pressure cleaner without rst completely unwinding the high-pressure
hose.
− When winding and unwinding the hose take care not to cause the high pressure cleaner to
overturn.
− Before unwinding or winding the hose, switch the machine off and release the pressure in the
hose itself (switching off).
5.3 RESIDUAL RISK
Important: Although the safety instructions and operating manuals for our tools contain extensive
instructions of safe working with power tools, every power tool involves a certain residual risk
which can not be completely excluded by safety mechanisms. Power tools must therefore always
be operated with caution!
5.4 CONNECTION TO THE POWER SUPPLY
Caution: Risk of electric shock. Do not open.
This appliance is supplied with an approved plug and cable for your safety. The value of the fuse
tted is marked on the pin face of the plug. Should the fuse need replacing, ensure the substitute
is of the correct rating, approved to BS1362 and ASTA or BS Kite marked.
ASTA
BSI
The fuse cover is removable with a small plain slot screwdriver. Ensure the fuse cover is replaced
before attempting to connect the plug to an electrical outlet. If the cover is missing, a replacement
must be obtained or the plug replaced with a suitable type.
If a replacement plug is to be tted this must be carried out by a qualied electrician.
The damaged or incomplete plug, when cut from the cable should be disabled to prevent
connection to a live electrical outlet.
This appliance is Class II† and is designed for connection to a power supply matching that detailed
on the rating label and compatible with the plug tted.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instructions supplied with the extension lead.
†
Double insulated
: This product requires no earth connection as supplementary insulation is
applied to the basic insulation to protect against electric shock in the event of failure of the basic
insulation.
IMPORTANT
If using an extension lead, follow the instructions that came with your lead regarding
maximum load while cable is wound. If in doubt, ensure that the entire cable is unwound.
Using a coiled extension lead will generate heat which could melt the lead and cause a re.
– 8 –
Loading ...
Loading ...
Loading ...