Loading ...
Loading ...
Loading ...
– 15 –
10. OPERATION
10.1 TOTAL STOP DEVICE
This pressure washer is tted with the Auto
Control Total Stop Device. This
will cause the motor to start and
stop when the trigger is activated,
unlike standard washers where the
motor would run continuously.
This device reduces the amount of
water and electricity used and the amount of wear
and tear on the machines components. Also this
helps cut down on the amount of noise emitted
during use.
10.2 SWITCHING ON – FIGS. 15 – 18
Note: Do not run the motor “DRY, and ensure the
machine is switched “OFF” prior to plugging in.
This pressure washer is designed to be used in the
upright position only.
To operate the pressure washer correctly carry out
the following steps:
− Make sure the power supply ON/OFF switch
(5)is set to the “O” – OFF position.
− Connect the pressure washer to the electricity
supply outlet.
− Connect and turn on the water supply.
Note: the trigger assembly section contains a
safety locking button (12.1)that is used to prevent
accidental operation.
− Pull the trigger (1)to bleed the air out of the
system.
− Whilst the trigger is pulled switch the power
supply ON/OFF switch (5)to the “I” – ON
position.
− When the air is purged release the trigger.
The machine is now ready for use. Ensure that
during use the jet is not aimed at people, animals,
electrical equipment or the pressure washer.
To achieve the desired spray pattern, rotate the
spray nozzle (7)(FIG.18).
After use:
− Switch off and unplug the pressure washer.
− Switch off the water supply.
− Pull the trigger to release the pressure and
drain the water.
− Disconnect the hose connection.
− Disassemble the lance, trigger and hose from
the machine.
− Drain all remaining water and store away safely.
15
16
FIG.
FIG.
17
18
FIG.
FIG.
(12.1)
(12)
(1)
(5)
(12.1)
Loading ...
Loading ...
Loading ...