Loading ...
Loading ...
Loading ...
EN - 18 WWW.SENIXTOOLS.COM
Hold the product as in working condition.
To start the product, keep pressing the safety switch,Then
squeeze the switch trigger (Fig.14).
To switch the product off, just release the switch trigger.
CHARGING THE BATTERY PACK
WARNING:
This Lithium-Ion battery pack is shipped partially
charged. Fully charge the battery pack before
using it for the first time.
NOTE:
Charging batteries at a ambient temperature of 32°F(0°C)-
104°F(40°C).
1. Charge the Lithium-Ion battery pack only with the
correct charger.
2. Connect the charger to a power supply, the light
indicator of the charger turns red.
3. Align the raised ribs of the battery pack with the slot in
the charger.
4. Insert the battery pack into the charger, the light
indicator of the charger turns green and it ashes
(Fig.15).
5. The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
6. It is fully charged that the four lights of the battery turn
on. Disconnect the power supply from the charger.
Remove battery pack from the charger.
CHARGING INDICATOR
Press the light button on the battery pack to check whether
it needs to charge (Fig.8).
Lights
Status
Lighted Off Blinking
The battery is at full
capacity.
The battery is at 75%
capacity.
The battery is at 50%
capacity and requires
charging.
The battery is at 25%
capacity and requires
charging soon.
The battery is less
than 5% capacity
and requires charging
immediately.
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the power tool/battery
cool before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the tool
and charge the battery.
HOLDING THE UNIT
• Stand in the operating position and stand up straight. Do
not bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right arm
slightly bent.
• Hold the handle with the left hand. Keep the left arm
straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the ground.
• Do not over-reach; Keep all parts of your body away from
the rotating cutting attachment and hot surfaces.
HANDLING POLE SAW
• Hold the pole saw with both hands.
• Wear the harness to carry the weight for maintain a
better control of the product.
• Fully grip both handles at all times during operation.
Never operate pole saw using only one hand.
• Hold the pole saw at a max. angle of 60° from the
Loading ...
Loading ...
Loading ...