Loading ...
Loading ...
Loading ...
16 17
Shake fully and clean the MixPro body to remove any foreign matter attached to it.
Wipe the surface of the machine body with a clean soft cloth, and make sure that
there is no water around the machine body and battery. Put them in a cool and
ventilated place to dry naturally.
3
4
* Do not use a hair dryer or blower.
Battery Storage and Maintenance
4
When the product is not in use, please take out the battery and store it separately.
The best storage conditions for the battery are 0-25°C, 60 ± 25% RH humidity, and
remaining power at 30%-50% . It should be separately stored in a cool and
ventilated place.
Do not leave the battery in places exposed to direct sunlight or high temperatures
(such as near microwaves or ovens), because it may overheat and potentially
explode.
Do not throw the battery into fire, otherwise it may catch fire or explode.
Do not charge the battery near fire or heat.
Do not drop, squeeze or puncture the battery as this may cause internal short
circuiting and overheating.
Do not disassemble or modify the battery. Unauthorized modification may cause
leakage or explosion.
Keep the battery out of the reach of children.
Do not charge the battery below 0°C.
When the battery is used below 0°C, the battery power will decrease sharply,
resulting in a sharp decrease in the running time.
For safety, the battery should be kept at low power during transportation.
Discharge it beforehand to 30%.
Do not use damaged batteries.
If electrolyte enters your eyes after battery leakage, do not wipe it. Wash it with
water, and consult a doctor immediately. If not handled in time, eyes will be hurt.
If stored for a long time, check the battery power at least every 3 months and
charge it to 60%.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Cleaning after Use
1
Maintenance
After each use, MixPro should be completely immersed in fresh water for 30
minutes to prevent residue from seawater or foreign objects. Also pay attention to
the following points.
Press both bottons so that the MixPro runs half in air and half in water for 3
seconds. Repeat 5-10 times.
1
2
* The battery must be installed before cleaning.
* Use fresh water.
* Immerse in water for more than 20 minutes.
* Do not add chemical cleaners such as laundry detergents or cleaning agent to the water.
* When the Mix Pro is immersed in water, some bubbles may emerge from holes of body.
This is normal.
* To prevent the water splashing on your body, keep the propeller outlet to the bottom of the
container.
* MixPro has a large thrust force in water. Use low speed, and slightly lift it up to the water
surface for easier control.
Loading ...
Loading ...
Loading ...