Loading ...
Loading ...
Loading ...
111
9 Vehicle
Information
Lap Belt Installation - DO NOT use in Booster Mode
Always review your vehicle owner’s manual for specific information about
your vehicle seat belts.
Locking Latch plate and No
Retractor
When installing the car seat, route the
lap seat belt through the proper path and
buckle it in. Then, pull upwards on the
tail of the belt so that the lap belt gets tight
around the car seat.
Sewn On Latch plate and ALR
Slowly pull the lap belt all the way out.
Route the vehicle seat lap belt through the
proper belt path and buckle it in. Then, pull
the lap belt tight while feeding all the slack
back into the retractor.
Grab the sides of the seat at the belt
path and slide the seat side-to-side
and front-to-back. The seat should
not move more than 1” (2.5 cm).
Sliding Latch plate and ELR Retractor
A latch plate that slides freely on the belt
webbing and cannot, by itself, hold the belt
snug around a car seat.
With this retractor, you will need to use the
locking clip to lock the vehicle seat belt.
To get a locking clip order online at
gracobaby.com or call 1-800-345-4109
Route the vehicle seat belt through the
proper belt path and buckle it in. Pull the
vehicle seat belt tight. While pushing down
on seat, pinch the two straps together
behind the buckle tongue. Unbuckle the belt
without allowing it to slip.
Attach locking clip to lap and shoulder belts
as shown.
Rebuckle belt. Check that lap belt does not
move by pulling hard. If belt loosens or
lengthens, repeat procedure.
Loading ...
Loading ...
Loading ...