Celestron 22066 AstroMaster LT 60AZ Telescope with Phone Adapter and Moon Filter

AstroMaster LT Manual - Page 8

For 22066. Also, The document are for others Celestron models: 21073, 21074, 31036

PDF File Manual, 100 pages, Read Online | Download pdf file

22066 photo
Loading ...
Loading ...
Loading ...
8 I ENGLISH
THE STAR DIAGONAL
The star diagonal attaches to the back of the 60 mm and 70 mm refracting telescopes and contains a small mirror that
reflects light at a 90° angle, providing a more comfortable viewing position. If you were to install the eyepiece directly into
the back of a refracting telescope, the image would be mirror reversed and upside-down. The star diagonal will flip the
image right-side up but the image will still appear mirror reversed left to right. This is normal for astronomical telescopes.
To insert the diagonal:
1. Remove the caps from both sides of the diagonal.
2. Loosen the setscrews on the back of the focuser and
pull out the small dust cap.
3. Insert the smaller tube on the diagonal into the back of
the focuser and secure it by tightening the setscrews.
You can adjust the angle of the star diagonal to any
desired direction before tightening the screws.
NOTE: A star diagonal will not reach focus on a Newtonian telescope. The image
will always appear upside-down.
THE EYEPIECE
Your telescope comes with two eyepieces. The 20 mm which will give low magnification with a moderately wide field of
view. The 10 mm will give you higher magnification, but a narrower field of view. Additional eyepieces can be purchased
to increase or decrease the magnification to your desired level. When first locating an object, it is best to use the 20 mm
eyepiece, then, once the object is centered, change to the 10 mm eyepiece to “zoom in” on it.
THE TELESCOPE TUBE
To attach the telescope tube to your tripod and mount:
1. Move the mount so that the telescope mounting platform
is parallel to the ground. Lock the altitude clutch to
prevent it from moving.
2. Locate the dovetail bar mounted on the bottom of the
telescope tube.
3.
Holding the telescope tube above to the mount, slide
the dovetail bar into the telescope clamp at the top
of the mount.
4. Tighten the large hand knob on the mounting screw to
secure the telescope in place.
NOTE: The 70 mm refractor is shown, but the 60 mm refractor and 114 mm
Newtonian attach to the mount in the same way.
Loading ...
Loading ...
Loading ...