Loading ...
Loading ...
Loading ...
5. Pivot seat and pan forward and as-
semble adjustment knob and flat
washer loosely.Do not tighten.
6. Lower seat into operating position and
sit in seat.
7. Slide seat untila comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving itsad-
justed position.
9. Raise seat and tighten adjustment
knob securely.
Seat I
Shoulder
Bolts
Adjustment Knob
CHECK BATTERY
I. Lift seat pan to raised position.
NOTE: Ifthis battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
9rminal
9
NOTE: You may now roll or drive your
tractor off the skid. Followthe appropriate
instructionbelow to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachment liftlever to its highest po-
sition.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place freewheel control in "trans-
mission disengaged" position (See "TO
TRANSPORT" in the Operation section
of this manual).
4. Roll tractor forward off skid.
5. Remove banding holdingdeflector
shield up against tractor.
TO DRIVE TRACTOR OFF SKID
(See Operation section for location
and function of controls)
_bWARNING: Before starting, read, un-
derstand and follow all instructionsin the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor isclear of other
people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel tank
with gasoline.
3. Place freewheel control in "trans-
mission engaged" position. (See 'q'O
TRANSPORT" in the Operation section
of this manual).
4. Sit on seat in operating position.
depress clutch/brake pedal and set the
parking brake.
5. Place motion control lever in neutral
(N) position.
6. Press lift lever plunger and raise
attachment lift lever to its highest posi-
tion.
7. Start the engine. After engine has
started, move throttle control to idle
position.
8. Release parking brake.
9. Slowly move the motion control lever
forward and slowly drive tractor off
skid.
10.Apply brake to stop tractor, set parking
brake and place motion control lever in
neutral position.
11. Turn ignition key to "STOP" position.
Continue with the instructionsthat follow.
Loading ...
Loading ...
Loading ...