Loading ...
Loading ...
Loading ...
• The average lawn should be cut to ap-
proximately 2-1/2 inches during the cool
season and to over 3 inches during hot
months. For healthier and better looking
lawns, mow often and after moderate
growth.
• For best cutting performance, grass over
6 inches in height should be mowed
twice. Make the first cut relatively high;
the second to desired height.
TO OPERATE MOWER
Your tractor isequipped with an operator
presence sensing switch. Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine. You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating
or cutting off when operating your equip-
ment on rough, rollingterrain or hills.
1. Select desired height of cut.
2. Start mower blades by engaging at-
tachment clutch control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
_.CAUTION: Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the deflector
shield in place.
Attachment .__
ClutchLever _))
"Engaged" _~
Oissng_ag_
PosiUon
Attachemnt
Uft Lever
• High
"_.Y Position
Position
Shield
TO OPERATE ON HILLS
_I_WARNING: Do not drive up or down
hillswith slopes greater than 150and do
not drive across any slope. Use the slope
guide at the back of this manual.
• Choose the slowest speed before start-
ing up or down hills.
• Avoid stopping or changing speed on
hills.
• If slowing is necessary, move throttle
control lever to slower position.
• If stopping is absolutely necessary, push
clutch/brake pedal quickly to brake posi-
tionand engage parking brake.
• Move motion control lever to neutral (N)
position,
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is depressed,
• To restart movement, slowly release
parking brake and clutch/brake pedal.
• Slowly move motion controllever to
slowest setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by placing
freewheel control in freewheeling position.
Freewheel control is located at the rear
drawbar of tractor.
1. Raise attachment liftto highest posi-
tion with attachment liftcontrol.
2. Pull freewheel control out and down
intothe slot and release so it is held in
the disengaged position.
• Do not push or tow tractor at more than
two (2) MPH.
• To re-engage transmission, reverse
above procedure.
Tranemlselon Engaged
Transmission Dlsengaged
NOTE: To protect hood from damage
when transporting your tractor on a truck
or a trailer, be sure hood isclosed and
secured to tractor. Use an appropriate
means of tying hood to tractor (rope, cord,
etc.).
14
Loading ...
Loading ...
Loading ...