Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART:
See appropriate section In manual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
Loss of power
1, Out of fuel.
2. Engine not "CHOKED"
properly.
3. Engine flooded.
4. Bad spark plug.
5. Dirty air filter.
6. Dirty fuel filter.
7. Water in fuel.
J8. Loose or damaged wiring.
!9. Carburetor out of adjustment.
10.Engine valves out of
adjustment.
! 1. Dirty air filter.
2. Bad spark plug.
3. Weak or dead battery.
4. Dirty fuel filter.
5. Stale or dirty fuel.
6. Loose or damaged wiring.
7. Carburetor out of adjustment.
8. Engine valves out of
adjustment.
1. Brake pedal not depressed.
2. Attachment clutch isengaged.
3. Weak or dead battery.
4. Blown fuse.
5. Corroded battery terminals.
6, Loose or damaged wiring.
7. Faulty ignitionswitch.
8. Faulty solenoid or starter,
9. Faulty operator presence
switch(es).
1. Weak or dead battery,
2. Corroded battery terminals.
3. Loose or damaged wiring.
4. Faulty solenoid or starter.
1. Cutting too much grass/too
fast,
2. Throttle in "CHOKE" position.
3. Build-up of grass, leaves and
trash under mower.
4. Dirty air filter.
5. Low oil leveVdirty oil.
1. Fill fuel tank.
2. See "TO START ENGINE" in
Operation section.
3. Wait several minutes before
attempting to start.
4. Replace spark plug.
5. Clean/replace air filter.
6. Replace fuel filter.
7, Empty fuel tank and carbure
tor,refilltank with fresh gas-
oline and replace fuel filter.
8. Check all wiring.
9. See "To Adjust Carburetor"
in Service and Adjustments
section.
10, Contact a Sears or other
qualifiedservice center.
1. Clean/replace air filter.
2. Replace spark plug.
3. Recharge or replace battery
4. Replace fuel filter,
5. Emptyfuel tank and refilltank
withfresh, clean gasoline.
6. Check all wiring.
7. See "To Adjust Carburetor"
in Service and Adjustments
section.
8, Contact a Sears or other
qualified service center.
1. Depress brake pedal.
2. Disengage attachment clutch.
3. Recharge or replace battery.
4. Replace fuse.
5. Clean battery terminals,
6. Check all wiring.
7, Check/replace ignition switch.
8. Check/replace solenoid or
starter.
9. Contact a Sears or other
qualified service center.
1. Recharge or replace battery.
2. Clean battery terminals.
3. Check all wiring.
4. Check/replace solenoid or
starter.
I1. Raise cutting height/reduce
speed.
2. Adjust throttlecontrol.
3. Clean underside of mower
housing.
4. Clean/replace air filter.
5. Check oil level/change oil.
30
Loading ...
Loading ...
Loading ...