Loading ...
Loading ...
Loading ...
– 15 –
9. OPERATING THE VACUUM CLEANER
9.1 OPERATING THE ASH VACUUM –
FIG. 8
Switch the machine on by pressing the on/off
switch .
NOTE: Return the battery to the charger
immediately after use so that it will be ready and
fully charged for the next use. Ensure that the
product is fully inserted into the charger.
IMPORTANT: The ash can should be positioned
on a rm, level surface. Do not cover the ash
can and always position it with good all-round air
ventilation. The ash can must remain upright.
1. Switch on the ash can and use the suction
tube to collect the ash.
2. When moving the ash can:
• Always use the handle.
• Do not lift it by (or place a strain on) the hose
or cable.
• Always switch it off and disconnect it from the
20V battery.
CAUTION: Make sure that replaces and stoves
are cold before you attempt to vacuum them clean.
Wait until the ash has cooled down completely
before you begin to collect it.
• Take care not to collect material
which appears to have cooled down on the
outside but which may still be hot on the
inside. Hot ash particles may ignite again in
the air ow.
• Any ash which has a temperature exceeding
40°C may damage the ash can.
3. Do not attempt to quickly extinguish res in
replaces or stoves with water in order to
achieve cool ash. The construction material
in the replace or stove may not withstand
any sudden variations in temperature and
suffer permanent damage.
4. Continuously check the tube and ash can
for excess temperature during use. If you
notice a signicant temperature rise, switch
off immediately and disconnect the ash can
from the power supply. Let the ash can cool
down under supervision before emptying the
vacuumed material.
CAUTION: Excessive temperatures can lead to
damage to the suction hose and the ash can and
cause a risk of re.
FIG. 8
Loading ...
Loading ...
Loading ...