Loading ...
Loading ...
Loading ...
– 13 –
8. PREPARING THE VACUUM CLEANER
FIG. 5
FIG. 6
1 FIG.
8.2 BATTERY PACK CHARGING –
FIG. 5
This power product us supplied “bare” without
battery pack or charger. Compatible batteries,
chargers and accessories are available through
Draper Tools stockists.
Important: Only Draper D20 designated battery
packs and chargers can be used in conjunction with
this product. Use of any other third party battery
packs/chargers with this product is considered
misuse and will invalidate the product’s warranty.
Once connected to the mains supply, recharging of
the battery can be left generally unsupervised,
requiring minimal attention. Complex circuit
construction monitors the battery condition, adjusting
the recharge current to suit. When the recharge cycle
is complete, to maintain the full capacity, a low output
current will continue as required.
Warning! Check the condition of the charger and
battery prior to each charge. If there is any sign of
damage then do not commence charging, seek
advice from Draper Tools.
The battery pack is supplied un-charged and must
be charged before initial use.
To charge the battery pack , it must rst be
removed from the tool.
To release the battery pack:
– Press the battery release button and
gently slide the battery pack off (Fig.5).
– Plug the battery charger unit into a 230V/
AC 13amp three pin supply socket.
– The red LED will illuminate to show the
charger has power.
– Slide the battery into the charger (the battery is shaped to t into the charger one way only.
– After a few seconds delay, the red LED will ash to show that charging has begun, then
illuminate solid red.
– Whilst the battery is charging, the green LED will ash, (the red LED will go from
ashing to constant red.
– When the battery is fully charged the green LED stops ashing and remains a constant
green. The red LED will extinguish.
Caution: Do not pull the plug out of the power supply by pulling on the cord. Make sure to grasp
the plug when removing from power supply to avoid damaging the cord.
To remove the battery from the battery charger:
– Supporting the battery charger with hand, pull out the battery from the battery charger.
Caution: If the battery charger has been in continuous use it will be hot. Once the charging has
been completed, leave the charger 15 minutes to cool until next use.
.
.
.
.
.
.
.
Loading ...
Loading ...
Loading ...