Loading ...
Loading ...
Loading ...
TO ADJUST BASE PLATE FOR BEVEL CUTI'ING (Ffgo 16 and 16a)
Z_ WARNING: ALWAYS unplug saw from the power source BEFORE
making any adJuslmenta or attaching accessories.
' NOTE: ALWAYS remove the blade before adjusting the cutting angle., I
1 After removing the blade from the saw. remove the vac adapter from under the base
(see Sawdust Removal, Page 16).
2 To adjust the cutting ang_a, first turn lhe tool upside down and use lhe hex key provided
on the power cord to loosen lhe hex screws that hold ,,hebfade guide rotlerstassemb_y
and saw base in p_ace (Fig 16)
3 Move the base ol the saw slightly ton,yard and tilt il to 1hedesired angle between O"
and 45" left or right, using fhe scale marked on Ihe base bracket
4. install a cutt{ng blade
5 Slide lhe blade guide rollers/assembly until the b_ade guide reliefs rest against lhe
back edge of the blade
6. Re-tighten the hex screws. For accurate work, it is necessary to make a trial cul.
measure the work, and reset the angle until the correct setting ts achieved (Fig 'f6a}
Z_ WARNING: ALWAYS clamp and support workplace securely. ALWAYS I
maintain proper control of saw. Failure to clamp and support workplace and
Joss of control of saw could result In serous Injury.
19
9-8-06
17235
Loading ...
Loading ...
Loading ...