Loading ...
Loading ...
Loading ...
7
OPERATING INSTRUCTIONS: DRY VACUUMING
The vacuum can be used as assembled or with the crevice tool. For your convenience, the
crevice tool is permanently built-in onto the top portion of the container.
1. Verify that the switch is in the OFF position before plugging in (Fig. 1).
2. Flip the crevice tool over to the fully extended position and push it into the container nozzle until
secured in place (Fig. 2).
3. Insert the detail brush into the front of the crevice tool (Fig. 3).
4. Insert the 12V power plug into the 12V power socket (Fig. 4).
NOTICE: Vehicle will typically need to be in 'ACCESSORY' mode in order for power to be supplied to
the socket.
5. Turn the motor on by sliding the switch to the ON position and begin vacuuming (Fig. 5).
6. After use, turn the vacuum o and disconnect the plug from the 12V power socket (Fig. 6).
7. Remove detail brush from the crevice tool and store it in the detail brush storage (Fig. 7).
8. Pull the crevice tool out of the container nozzle and ip it forward towards the front of the unit and
lock into place (Fig. 8).
9. Empty the container, clean and dry the inside and outside before storage (Fig. 9 & 10).
2
5
1
4
3
10
7 8 9
6
Loading ...
Loading ...
Loading ...