Loading ...
Loading ...
Loading ...
① Put the water tray on the desktop and push it to the bottom of the machine (stuck it
between the two rubber)
② The machine will be connected to the water source
1. Manual refill water mode: pull out the drawer, then add the water to the liner. The
water level shall not exceed the maximum water level line in the liner (MAX mark). Put
back the drawer. Note: drawer should put back thoroughly.
2. Auto refill water mode(recommended to use drinkable room temperature filtered
water): connect the tap water inlet pipe to the water inlet connector on the back panel,
then turn on the faucet (water supply water pressure must be controlled between
100kpa ~ 800kpa)
3. Plug the power cord into the socket, then connect the rated power.
4. After the power is on, the power light flashes. Then press the "POWER" button, the
pump starts to pump water and start making ice.
5. Pressing the "LIGHT" button, the internal light will turn on. Press the "LIGHT" button
again, the light will go out and the internal light will turn off.
6. Long pressing "CLEAN" button for 3 seconds, it will enter the cleaning mode. Then the
"CLEAN" button lights up , and the machine enters the automatic cleaning mode. The
automatic cleaning will last 8 minutes to end.
7. To stop making ice, pressing the "POWER" button, the power indicator flashes state.
And the machine enters the cleaning state. Motor, pump start to operate. After 5
minutes cleaning, motor, pump stop running, indicating the cleaning is done.
HOW TO START THE UNIT
Seals
Water inlet fitting
double-ended inlet tube
Operation & Maintenance
07
Loading ...
Loading ...
Loading ...