Loading ...
Loading ...
Loading ...
REAR HITCH SPECIFICATIONS PER COMPONENT CERTIFICATE
Approval #
E20 55R-01 4430
Maximum Dynamic Force (D)
10,2 kN
REAR HITCH CERTIFICATION LABEL
The hitch certification label is located
near the hitch on models equipped with
a factory-installed rear hitch.
HITCH REMOVAL / INSTALLATION
1. To remove the hitch, remove the cotter pin
q
and hitch pin
w
. Remove the
hitch, then reinstall the hitch pin
w
and secure the cotter pin
q
.
2. To install the hitch, remove the cotter pin
q
from the hitch pin and remove
the hitch pin
w
.
3. Install the hitch to the receiver.
4. Reinstall the hitch pin (from the left side of the hitch) through the bore of both
the receiver and the hitch.
5. Reinstall the cotter pin. Make sure the hitch assembly is secure at that the
cotter pin is properly engaged over the hitch pin.
NOTICE
After 1000 km of use, tighten the bolt holding the trailer ball to the hitch to 445
N·m.
51
FEATURES AND CONTROLS
Loading ...
Loading ...
Loading ...