Loading ...
Loading ...
Loading ...
Installation
Leveling
To protect personal property and refrigerator
from damage, observe the following:
•Protect vinyl or other flooring with cardboard, rugs,
or other protective material.
• Do not use power tools when performing leveling
procedure.
To enhance the appearance and maintain performance
the refrigerator should be level.
Note
• Complete any required door reversal, panel
installation and/or a water supply connection,
before leveling.
Materials Needed:
• 3/8"hex head driver
• Carpenter's level
1. Remove toe grille.
• Grasp firmly and pull bottom
outward to unclip.
2. Remove bottom bracket cover(s).
• Place the eraser end of a pencil or similar blunt
tool in the cover notch.
Notch
Location
• Use slight pressure to pry the
cover loose.
.
• Continue to maintain
downward pressure to the
notched side of the cover while
swinging it off.
Using hex head driver, turn both of the front
adjustment screws (A) clockwise to raise and
counterclockwise to lower the front of the
refrigerator.
4. Turn both rear adjustment screws (B) clockwise to
raise and counterclockwise to lower the rear of the
refrigerator.
5. Using the carpenter's level, make sure front of
refrigerator is '/4"(6 ram) or '/8bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
6. If doors are uneven, do the following:
• Determine which door needs to be raised.
• Turn front roller adjustment screw (A) clockwise
to raise front corner of door.
• If one refrigerator
door has reached
the limit of its
adjustment range
and doors are still
not level, raise or
lower the opposite
door by turning roller
adjustment screw
counterclockwise.
• Check with level to verify '/4"tilt to the back for
proper door closure.
• If refrigerator is aligned and stable, replace toe
grille and hinge covers.
7. Replace bracket cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
8. Replace the toe grille.
Note
• For proper reinstallation, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Loading ...
Loading ...
Loading ...