Loading ...
Loading ...
Loading ...
Troubleshooting
Ice forms in inlet
tube to ice maker Water pressure is low.
Saddle valve not open completely.
Freezer temperature is too high.
Refrigerator is Plastic tubing was used to complete
leaking water water connection.
Improper water valve was installed.
Water flow is Water pressure is low.
slower than normal
Saddle valve not open completely.
Improper water valve was installed.
Copper tubing has kinks.
Water pressure must be between 35 to 100 pounds per
square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Open saddle valve completely.
See TemperatureControls pages 12, 13 and 14.Freezer
temperature should be between 0° to 2° F(-18° to -17°C).
The manufacturer recommends using copper tubing for
installation. Plastic is less durable and can cause
leakage. Sears is not responsible for property damage
due to installation or water connection not performed
by Sears.
See Connecting the Water Supply page 11.Self-piercing
and 3/Z'saddle valves cause low water pressure and
may clog tile line over time. Sears is not responsible
for property damage due to installation or water
connection not performed by Sears.
Water pressure must be between 35 to 100 pounds per
square inch to function properly. A minimum pressure
of 35 pounds per square inch is recommended for
refrigerators with water filters.
Open saddle valve completely.
See Connecting the WaterSupply page 11.Self-piercing
and 3/Z'saddle valves cause low water pressure and
may clog the line over time. Sears is not responsible
for property damage due to installation or water
connection not performed by Sears.
Turn off water supply and remove kinks.
If kinks cannot be removed, replace tubing.
Change water filter (see page 21).Water filter is clogged or needs to be
changed.
Refrigerator has been recently installed.
Water supply in holding tank has been
depleted.
Water has settled into water lines
outside holding tank and has warmed to
room temperature.
Air or air bubbles in water.
Dispenser water Allow approximately 12 hours for water in holding tank
is not cold to chill.
Discard first glass of water and refill.
Water appears This is normal when first using the dispenser and will
cloudy disappear with use.
Particles in water Carbon dust from water filter cartridge. Initial water ejected through cartridge may contain
and/or ice cubes, harmless carbon dust flushed from cartridge.
Particles are safe for consumption.
Will disappear after the first few uses.
Concentrations of minerals in water will Particles are not harmful and naturally occur in water
form particles when water becomes supplies.
frozen and melts.
35
Loading ...