Loading ...
Loading ...
Loading ...
Alarm
The watch will beep when an alarm time is
reached.
The hourly time signal causes the watch to
beep every hour on the hour.
●
If flash alert is enabled, display illumination
will flash along with the alarm beeper and
the hourly time signal.
l
Configuring Flash Alert Settings
Configuring Alarm Settings
There are various alarm variations, and the
variation that is set depends on the hour,
minute, month, and day settings you
configure.
●
Configuring Some of the Settings (hour,
minute, month, day)
ー
Hour and Minute Settings Only
The alarm sounds every day at the
specified time.
ー
Month, Hour and Minute Settings Only
The alarm sounds every day of the
specified month at the specified time.
ー
Day, Hour and Minute Settings Only
The alarm sounds every month at the
specified time on the specified day.
●
All Settings: Hour, Minute, Month, Day
The alarm sounds once at the specified time
on the specified date.
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (A).
This causes the hours digits to flash.
Hours
3. Keep pressing (C) until the setting you
want to change is flashing.
●
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Day
Month
Minutes
Hours
4. Use (B) to change the value.
●
Holding down (B) scrolls through
settings at high speed.
●
[-] is displayed for the month and [- -] is
displayed for the day if nothing is
specified for these settings.
●
While you are setting the timekeeping
hour, [PM] (p.m.) is displayed during
p.m. times if you are using 12-hour
timekeeping, while [24H] is displayed if
you are using 24-hour timekeeping.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
●
A beeper sounds for 20 seconds to let
you know when the alarm time is
reached.
●
If flash alert is enabled, display
illumination flashes along with the
alarm beeper and the hourly time
signal. Pressing any button to stop the
alarm beeper also stops the flash alert
operation.
l
Configuring Flash Alert Settings
Watch Operation Guide 3523
7
Loading ...
Loading ...
Loading ...