Loading ...
Loading ...
Loading ...
14
www.insigniaproducts.com
If you are installing your refrigerator between frameless cabinets, a 0.5 in.
(1.3 cm) wide filler strip or side panel may be needed on both sides of your
refrigerator. The filler strip provides a space between the appliance case and
the adjacent cabinet door swing. The width of the opening must include the
filler panels. The door should extend at least 1 in. (2.6 cm) beyond the
surrounding cabinets.
Preparing your refrigerator
If your refrigerator will be built into an enclosure the compressor cover must
be removed to allow air flow around the compressor, so that it does not
overheat. Keep the cover and screws in a safe place so that they can be used
again in the future if necessary.
Notes:
• The indicated depth requirement assumes that the electrical outlet is located
in the adjacent cabinet or is flush mounted (not surface mounted) in the rear
wall of the enclosure.
• If the electrical outlet is located inside an adjacent cabinet, cut a 1.5 in.
(3.8 cm) diameter hole to route the power cord. If the cabinet wall is metal,
the hole edge must be covered with a bushing or grommet to protect the
cord.
1.5 in. (3.8 cm) diameter
(if electrical outlet is in adjacent
cabinet)
2 in. (5 cm)
25 in. (63.5 cm) min.
35 in. (88.9 cm) min.
6 in. (15.2 cm)
90°
24 in. (61 cm) min.
Loading ...
Loading ...
Loading ...