Loading ...
Loading ...
Loading ...
EN - 10
grid (28) and empty it.
• Clean the tray (14) and the grid (28) in
running water with neutral dish detergent.
• Dry the components and reassemble them
in the machine.
Do not clean components,
especially the cup holder grid, in
the dishwasher.
We recommend you clean the
external drip tray daily.
Cleaning the coffee grounds
container (12) and internal tray (13)
Always empty the coffee grounds
container with the appliance
switched on. This is the only way
of resetting the coffee grounds
counter. The counter resets at
least 15 seconds after opening
the various components and LED
23 ashes.
• Remove the tray (14).
• Remove the grounds container (12) with its
tray (13) by pulling it outwards.
• Empty the coffee grounds from the container
(12).
• Clean the container (12) and the tray (13)
in running water with neutral dish detergent.
• Thoroughly dry components and reassemble
on the machine.
When emptying the grounds
container, be sure to also empty any
water residue from the internal tank.
Daily cleaning of the coffee grounds
container and internal tray is
recommended.
It is normal to nd water residue in
the internal tank. Clean and dry.
Cleaning the water tank (5)
• Remove the lid (4) and remove the tank (5)
from the machine using the appropriate
handle.
• Clean the tank (5) in running water with
neutral dish detergent and reassemble it in
the machine.
The presence of lime scale inside
the tank could cause the appliance
to malfunction. Make sure the tank
is always clean and without lime
scale stains.
Cleaning the brewing group (15)
We recommend cleaning the
brewing group at least once a
week.
• The coffee machine indicates when brewing
group cleaning is recommended (steady lit
LED 24).
• With the machine on, press the lower part
of the door (8) until it is released and slide
it out from the top.
• Press the two release clips (29) located on
the sides of the infuser (15) and remove it
from the machine
(Fig.L).
• Wash the brewing group (15) with running
water and dry it.
• Thoroughly clean its housing and the duct as
well, using the cleaning brush (31) supplied,
as in Figure F.
• Dry thoroughly before re-mounting the
various components.
• Ret the service door (8) making sure it is
correctly positioned.
Cleaning and maintenance
Loading ...
Loading ...
Loading ...