Tripp Lite B126-4X4 Owner’s Manual

Loading ...

Remote Repeater Installation

Using Cat5e/6 cable, connect the RJ45 output port on the last repeater

to the RJ45 input port on a B126-1A0 or B126-1A0-WP-1 receiver.

Connect a monitor to the HDMI output port on the receiver using a

Tripp Lite P568-Series High-Speed HDMI cable.

Connect the external power supply to the active remote receiver

unit, and plug it into a Tripp Lite Surge Protector, PDU, or UPS. When

receiving power, the Green RJ45 LED on the B126-1A0 and the Green

Power LED on the B126-1A0-WP-1 will illuminate.

Repeat steps 7 through 15 for the remaining Output ports on the switch.

Turn on power to the connected devices. The Orange RJ45 LEDs on the

B126-2X2, B126-4X4, B126-110, and B126-1A0, and the Orange

Activity LED on the B126-1A0-WP-1 will illuminate. The video image

should now be displayed on the connected monitors.

If necessary, use the Equalization control on the repeater and receiver

units to adjust the video image.

Note: An improper Equalization setting can cause the monitor not to display an image at all. Try

each setting until an acceptable image is displayed.

Press the switch next to each set of Output LEDs to switch the source

being displayed on the corresponding Output monitor. You can also use

the included remote control to switch between sources. As with the

switch next to the Output LEDs, press the button on the remote control

of the desired Output port to switch the source being displayed.

Note: The same 4 button remote control comes with both the B126-2X2 and B126-4X4.

Buttons 3 and 4 will not be used for the B126-2X2.

See the RS-232 Serial Control section in this manual for details on

controlling the switch using Terminal Emulation Software.

17-06-500-9333F8-EN.indd 9 7/10/2017 1:20:50 PM

Loading ...

Tripp Lite B126-4X4 4 x 4 HDMI over Cat5/6 Matrix Splitter Switch, Box-Style Transmitter