Loading ...
Loading ...
Loading ...
REPLACING BATTERY
n_aWARNING: Do not short battery terml-
y allowing awrench or any other object
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Liftseat pan to raised position.
2. Remove terminal cover.
3. Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
4. Installnewbatterywithterminals insame
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten securely.
7. Connect BLACKgroundingcableto nega-
tive (-) battery terminal with remaining
bolt and nut. Tighten securely
8. Lower seat pan.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE HOOD & GRILL ASSEMBLY
1. Raise hood.
2, Unsnap headlight wire connector,
3, Stand in frontof tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor,
4. When replacing hood, Ensure to recon-
nect the headlight wire connector.
__ho tHood
ire
TRANSMISSION REMOVAL!REPLACE-
MENT
Should yourtransmission require removal for
service or replacement, it should be purged
after reinstallation and before operating the
tractor. See "PURGE TRANSMISSION" in
the Operation section of this manual,
Terminal Nut
Negative Bolt ENGINE
Cover\___\-- (Black) TO ADJUST THROTTLE CONTROL
The throttle control has been preset at
Positive the factor:/and adjustment should not be
(Red) necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
TO-R EPLACEHEADLIGHT BULB...................................................................................................................................................
t. Raise hood. The choke control has been preset at the
2. Remove bulb holder from the hole in the factory and adjustmentshould not be neces-
sary. If adjustment is necessary, see engine
backside of the grill, manual.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the TO ADJUST CARBURETOR
backside of the grill. Yourcarburetor has been presetatthefactory
4. Close hood. and adjustment should not be necessary.
However, minor adjustment may be required
INTERLOCKS AND RELAYS to compensate for differences in fuel, tem-
Loose or damaged wiring may cause your perature, altitude or load. Ifthe engine does
tractorto run poorly, stop running, orprevent need adjustment, see engine manual.
it from starting,
• Check wiring.
...... 26
Loading ...
Loading ...
Loading ...