Tripp Lite B162-001-POE Owner's Manual

Loading ...

11. CLI Commands

11.4.11 Conﬁguring EDID Mode

To set the EDID mode of a speciﬁed B162-001-POE transmitter, type the command in this format:

edid + i<port> + <EDID_mode> + \r\n

Control Description

i<port> Indicates the device ID, MAC address or IP address of the transmitter

(B162-001-POE) connected to the source of the target display.

<EDID_mode> Indicates the EDID mode you wish to set to the speciﬁed transmitter. Valid

inputs include:

• Default – Sets up the input to an optimum conﬁguration based on EDID

predeﬁned by Tripp Lite.

• Auto – Sets up the input to the highest resolution of the connected displays.

• Manual – Sets up the input to user’s conﬁguration.

• Remix –

Sets up the input to an optimum resolution of the connected displays.

\r\n Ends the command.

Example:

• To set the EDID mode of a transmitter with the device ID of 16 to auto, type edid i016 auto

11.4.12 Rebooting the B162 Units

To reboot a B162 transmitter or receiver, type the command in this format: reset + a<port> | i<port> |o<port> + \r\n

Control Description

a<port> Indicates the device ID or IP address of the target transmitter or receiver.

i<port> Indicates the device ID of the target input device (B162-001-POE).

Use an asterisk (*) to target all transmitters in the environment.

o<port> Indicates the device ID of the target output device (B162-100-POE).

Use an asterisk (*) to target all receivers in the environment.

\r\n Ends the command.

Example:

• To reboot the transmitter with the IP address of 10.0.60.13, type reset i10.0.60.13 or reset a10.0.60.13

• To reboot all receivers, type reset o*

Loading ...

Tripp Lite B162-001-POE HDMI over IP Encoder