Rowenta DR2020U1 Pure Pop Handheld Garment Steamer

User Manual - Page 27

For DR2020U1. Also, The document are for others Rowenta models: DR20**, DT20**

PDF File Manual, 30 pages, Read Online | Download pdf file

DR2020U1 photo
Loading ...
Loading ...
Loading ...
26 27
NO
1H
6
NETTOYAGE /
CLEANING /
LIMPIEZA
Espere una hora a que el aparato se
enfríe por completo.
ES
Attendez une heure pour que votre
appareil refroidisse complètement.
FR
Wait an hour for the appliance to
completely cool down.
EN
Remove the pad* from the appliance.
Clean the plastic parts of the
appliance with a dry cloth. Do not use
any detergent.
EN
Retira la almohadilla del aparato.
Limpie las piezas de plástico del
aparato con un paño seco. No utilices
ningún detergente.
ES
Retirez le pad* de lappareil. Nettoyez les
pièces en plastique de lappareil avec un
chion doux. Nutilisez pas de détergent.
FR
Never wash or rinse appliance directly
over a sink.
EN
Nunca lave ni enjuague el aparato
directamente bajo el grifo.
ES
Ne lavez ni ne rincez jamais lappareil
directement sous le robinet.
FR
The reversible pad* can be hand
washed with clear water and soap. Let
it dry before reusing it.
EN
Las almohadillas* reversibles se
pueden lavar a mano con agua y
jabón. Deja que se sequen antes de
volver a utilizarlas.
ES
Le pad* réversible peut être lavé à la main
avec de leau claire et du savon. Attendez
quil soit sec avant de le réutiliser.
FR
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES SOLUTIONS
There is no steam. The appliance is not plugged in, or
not switched on.
Check that your appliance is correctly
plugged in and switched on.
Then wait for approximatively 15 sec
for steam to be available..
The water level is too low / the
pump cannot reach the water.
Regularly bring your appliance back to
a vertical position. If still not working,
unplug your appliance and rell it.
The steam pump has not been
primed.
Press the steam trigger continuously
until the steam appears.
You are using the appliance for the
rst time.
Press the steam trigger continuously
until the steam appears.
The water tank is not fully in place. Make sure the water tank is correctly
set by sliding it up.
The appliance does
not heat.
It is not plugged in, or not switched
on.
Plug in your appliance and switch on.
Water tank leaks. The water tank is not fully in place. Make sure the water tank is correctly
set by sliding it up.
Steam rate decreases or
releases particles.
Calc build-up Refer to ANTI CALC’ section in
instructions for use.
The steam leaves stains
on the fabric or the
appliance spits
You are using water with additives. Never add any additive in the water
tank.
The appliance has not been
rinsed enough after the descaling
operation.
Read carefully the ANTI CALC section
in instructions for use.
You are using other liquids than
white vinegar to descale the
product.
Use only white vinegar during ANTI
CALC’ procedure.
The heating light is
switching o during
use.
It is not a defective sign. The light
switch on and o during the heating
regulation.
None, it is normal.
Water leaks from steam
head.
The appliance has been in a tilted
position for too long or is in a
horizontal position.
Do not stay too long on a tilted
position and regularly comeback in a
vertical position. Do not use your
appliance in a horizontal position.
* EN Depending on model / * ES Según el modelo / * FR Selon le modèle
Loading ...
Loading ...
Loading ...