Loading ...
Loading ...
Loading ...
8 | nuwavenow.com
GETTING STARTED
MEASURING AIR QUALITY
Measuring Air Quality: The OxyPure Sensors
The NuWave OxyPure has two sensors to monitor the state of your air, one for air quality and the other
for odor.
Air and Odor LEDs
The OxyPure will display the Air/Odor quality based on the particulate matter in the air from low to high
as represented below. If the PM level in the air exceeds the upper limit of the range, a warning is trig-
gered with a beeping sound and a ashing LED. To turn off this warning, press AUTO and Fan Speed
at the same time. Press the same buttons to turn the warning feature back on.
Particulate Matter (PM) with a diameter of 2.5 microns or less
0~5 5~10 10~20 20~30 30~50 Over 50
EZ Mode
1. Tap the + symbol, then select the Oxy-
Pure unit you want to add to the network.
2. Enter and conrm your Wi-Fi network
password.
3. Tap AP Mode in the top right of your
screen, then select EZ Mode to switch
pairing modes.
4. Conrm that the Wi-Fi light on your Oxy-
Pure is blinking rapidly.
5. Once the OxyPure is connected, tap
Done.
If the OxyPure did not connect to your
network, the Wi-Fi light will turn off. Repeat
the steps for pairing. Make sure to select the
proper Wi-Fi network and type the correct
password.
Note: If your home network doesn’t broad-
cast in a 2.4GHz or a dual band broadcast
frequency, contact your ISP to inquire about
setting up a 2.4GHz network.
THE NUWAVE CONNECT APP
MONITOR AND CONTROL THE OXYPURE REMOTELY
AP Mode
1. If you can’t connect your OxyPure using
Auto Scan, follow the instructions in the
app to reset the connection process.
2. Press and hold ULTIMATE CLEAN until
the Wi-Fi light begins blinking slowly to
enable AP Mode.
3. Tap the + symbol, then select the Oxy-
Pure unit you want to add to the network.
4. Conrm that the Wi-Fi light on your Oxy-
Pure is blinking slowly and tap AP Mode
on your phone screen.
5. Connect your phone to the available
hotspot following the instructions on the
screen.
6. Once connected, return to the NuWave
Connect app and the unit will begin con-
necting automatically.
7. Once your OxyPure is successfully con-
nected, tap Done.
If you’re unable to pair your OxyPure using Auto Scan, you can alternatively try one
of the following pairing methods.
Loading ...
Loading ...
Loading ...