Loading ...
Loading ...
Loading ...
Page 9
OPERATION
MAINTENANCE
WARNING:
To avoid serious
personal injury, always disconnect the
plug from the power source when cleaning
or performing any maintenance. Contact a
qualied service technician for ALL repairs.
WARNING:
Avoid using solvents
when cleaning plastic parts. Most plastics
are susceptible to damage from various
types of commercial solvents and may be
damaged by their use. Use a clean cloth to
remove dirt, dust, oil, grease, etc.
BATTERY CHARGING
If the battery pack is within the normal
temperature range, the green LED will begin
flashing and the red LED will be off, the four
green LEDs on the battery pack will flash
one by one from right to left.
BATTERY FULL
After the battery is fully charged, the green
LED Light on the charger will be on and the
red LED light will be off; the green LEDs on
the battery will shine for approximately 30
minutes and then turn off.
NOTICE: The battery pack will fully charge,
but will not overcharge, if left on the charger.
NOTICE: Charger may warm with several
continuous charge cycles. This is part of
the normal operation of the charge. Charge
in a well ventilated area.
WALL-MOUNT HOLES
The charger has hanging holes for conve-
nient storage. Install screws in the wall 3-1/4
inches apart. Use screws sufficiently strong
to hold the combined weight of the charger
and battery pack.
WARNING:
If the supply cord
is damaged, it must be replaced by a
specially prepared cord available through
the service organization.
WARNING:
When servicing, use
only identical replacement parts. Use of any
other parts may create a hazard or cause
product damage. To ensure safety and
reliability, all repairs should be performed
by a qualied service technician.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The battery pack isn’t
charging
Unconnected to charger
Attach the battery pack to
the charger.
Loading ...
Loading ...
Loading ...