Loading ...
Loading ...
Loading ...
Names of Machine Parts
GETTING READY
9
1
■ Main parts
1 Bobbin winding thread guide and pretension disk
(page 18)
2 Thread guide (page 18)
3 Spool cap (page 18)
4 Spool pin (page 18)
5 Bobbin winder (page 17)
6 LCD (liquid crystal display) (page 13)
7 Operation panel (page 10)
8 Operation buttons (page 10)
9 Embroidery unit (page 29)
0 Thread cutter (page 22)
A Needle threader lever (page 23)
B Thread tension dial (page 35)
C Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle.
D Thread guide cover (page 18)
E Handle
Carry the machine by its handle when transporting.
F Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot.
G Main power switch (page 12)
H Power supply jack (page 12)
I Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
J USB port (for a USB flash drive) (page 43)
■
Needle and presser foot section
1 Needle bar thread guide (page 22)
2 Needle plate
3 Needle plate cover (page 20)
4 Bobbin cover/bobbin case (page 19, page 46)
5 Embroidery foot (page 33, page 47)
The embroidery foot helps control fabric flexibility for better
stitch consistency.
6 Embroidery foot screw (page 47)
Use the embroidery foot screw to hold the embroidery foot in
place.
■ Embroidery unit
1 Embroidery carriage frame holder (page 29)
2 Embroidery unit connection (page 25)
3 Carriage (page 25)
4 Release button (page 26)
Chapter 1
GETTING READY
Note
• Be sure to install the latest software.
Refer to “Updating Your Machine’s Software” on
page 56.
Names of Machine Parts
a
b
c
d
e
f
g
h
i
j
k
l
m
n
o
p
q
r
s
t
IMPORTANT
• Do not insert anything other than a USB flash
drive into the USB port. Anything else may
damage the machine.
b
a
c
d
e
f
a b
c
d
Loading ...
Loading ...
Loading ...