Loading ...
Loading ...
Loading ...
RP4-MZ11
Radio Replacement & Steering Wheel Control Interface
for Mazda Vehicles
Pacic Accessory Corporation
®
| Santa Ana, California 92705 | Ph. 866-931-8021 | [email protected]
©2012 Pacic Accessory Corporation
www.pac-audio.com
Pacific Accessory Corporation
Rev. 081612
Page 6
SWC Recalibration
SWC re-calibration is necessary when the SWC operation is erratic or non-existant. This process re-calibrates the SWC values
to the RP4 interface so it will know what they can be set to for button function assignment. The interface must be programmed
in the specic order shown in the chart below. If you come across a function in the chart that your steering wheel does not have
you MUST press and release the program button on the side of the interface to skip that function. The LED will ash off and on
conrming that you have successfully skipped that function and are ready to proceed to the next one.
The SWC and radio command assignments can always be restored to default values by entering re-calibration mode (Steps
A-C) and not pressing any buttons. After 7 seconds the re-calibration mode will time out and all default values will be restored.
After you have re-calibrated the SWC buttons, the default SWC button assignments will be the same as what is listed in the
chart on page 3. If you wish to re-assign button functions you must also go through the programming process on page 4.
Step B.
Press and
hold the
programming
button for 7
seconds
Step C.
Release the
programming
button.
LED will begin ashing
SWC Connection
See above chart for
different radio type
connections
x4
SWC Connection
See above chart for
different radio type
connections
x4
SWC Connection
See above chart for
different radio type
connections
x4
Step A.
Turn the vehicle ignition to
the ON position.
OFF
ACC
IGN
STRT
SWC Connection
See above chart for
different radio type
connections
x4
Step E.
Release the button.
The LED will turn on
back on.
Step D.
Within 7 seconds,
press and release the
button that is to be
learned on the steering
wheel.
The LED will
turn off during
this process.
SWC Connection
See above chart for
different radio type
connections
x4
VOL
VOL
Step F.
If you need to program more buttons,
repeat steps D & E for each additional
function on the steering wheel.
Program
remaining buttons
SWC Connection
See above chart for
different radio type
connections
x4
Once programming is
completed, wait 7 seconds.
The LED will ash four
times indicating the end of
programming.
Step G.
After all buttons are
programmed
ButtonProgrammingOrder
VolumeUp
VolumeDown
TrackUp
TrackDown
Mode
Mute
Voice
Phone Hang Up
Phone Answer
Product Updates (Firmware)
The RP4-MZ11 can be updated with new rmware as it becomes available using the PAC-UP interface updater (sold seperatly).
Please visit www.pac-audio.com/rmware for available updates.