Loading ...
Loading ...
Loading ...
Note: Some accessories, such as scrapers
or blades, may be mounted either straight on
the tool, or at an angle to enhance usability
(Fig. 6).
In order to do this with the Easy-Lock
interface, place the accessory onto the
accessory holder making sure the accessory
engages all pins in the holder and the
accessory is flush against the accessory
holder. Securely lock the accessory in place
as described previously (Fig. 2).
REMOVING ACCESSORIES WITH
EASY-LOCK ACCESSORY CHANGE
1.To remove an accessory, first loosen the
clamping knob by twisting it in a counter-
clockwise direction (Fig. 2).
2.Press the clamping knob and lift the
accessory bracket to take it off the pins.
You may need to loosen the clamping
knob more to allow adequate room to
remove the accessory. (Fig. 3)
Note: Blade may be hot after use, wait for
blade to cool down before touch.
-10-
LEARNING TO USE THE TOOL
Getting the most out of your oscillating tool is a
matter of learning how to let the speed and the
feel of the tool in your hands work for you.
The first step in learning to use the tool is to
get the “feel” of it. Hold it in your hand and feel
its weight and balance (Fig. 7). Depending on
the application, you will need to adjust your
hand position to achieve optimum comfort and
control. The unique comfort grip on the body of
the tool allows for added comfort and control
during use.
Operating Instructions
FIG. 7
FIG. 6
INSTALLING AND REMOVING
SANDING SHEETS
Your backing pad uses hook-and-loop backed
sandpaper, which firmly grips the backing pad
when applied with moderate pressure.
1. Align the sanding sheet and press it onto
the sanding plate by hand.
2. Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This will
promote good adhesion and helps to
prevent premature wear.
3. To change, merely peel off the old sanding
sheet, remove dust from the backing pad if
necessary, and press the new sanding
sheet in place.
After considerable service the backing pad
surface will become worn, and the backing pad
must be replaced when it no longer offers a
firm grip. If you are experiencing premature
wear out of the backing pad facing, decrease
the amount of pressure you are applying
during operation of the tool.
For maximum use of abrasive, rotate pad 120
degrees when tip of abrasive becomes worn.
1600A014GW MM35 08-18.qxp_MM35 8/23/18 9:06 AM Page 10
Loading ...
Loading ...
Loading ...