Loading ...
Loading ...
Loading ...
The Rear Panel
SW1 (SUSTAIN) and SW2 Jacks
9
GETTING STARTED GUIDE
In Multi Mode, pedal assignments can vary per Multi. Pedal assignments can be adjusted for
each Zone by using Multi Edit Mode.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for
all Programs and Multis.
NOTE : Switch pedals must be plugged in before powering on the SP6.
Do not to step on the switch pedals when powering on the SP6, as the
state of the pedals is detected as part of the start up sequence.
Dual Switch Pedals
๎e SW1 (SUSTAIN) and SW2 jacks can be connected to dual switch pedals (2 pedals per
jack), allowing up to four switch pedals to be used. Compatible pedals should use a single 1/4
inch tip-ring-sleeve plug.
Pedals plugged into the SW1 (SUSTAIN) jack are referred to as SW1a and SW1b, and pedals
plugged into the SW2 jack are referred to as SW2a and SW2b. In Program Mode the default
assignments are:
SW1a
Sustain
SW1b
Sostenuto
SW2a
Sostenuto
SW2b
Soft Pedal
To emulate the 3 pedals of an acoustic piano, plug a single switch pedal into the SW1
(SUSTAIN) jack, and a dual switch pedal into the SW2 jack.
Continuous Switch Pedals (Half-Damper)
๎e SW1 (SUSTAIN) jack is also compatible with continuous switch pedals (Half-Damper)
that use a 1/4 inch tip-ring-sleeve plug (such as the Kurzweil KP-1H). When connected to the
SW1 (SUSTAIN) jack, a Half Damper pedal enables ๎ner control of sustain than a standard
switch pedal. Half Damper control is enabled for Programs in the Piano category. Programs
outside of the Piano category will respond to a Half Damper pedal as if it is a standard switch
pedal.
Loading ...
Loading ...
Loading ...