Loading ...
Loading ...
Loading ...
P a g e |
15
web: brohn.com.au
Engage wires into plastic clip. Secure plastic clip.
Replace cover plate onto rear panel.
Connection Diagram
220-240 V earthed one-phase connection
L (Brown) wire to terminal marked “L”
N (Blue) wire to terminal marked “N”
E (Yellow-Green) wire to PE terminal
Connecting the electricity supply cable to the mains
Ovens equipped with a three-pole power supply cable are designed to operate
with alternating current at the voltage and frequency indicated on the data
plate located on the appliance.
The Data Plate located on the oven frame behind the door gives information about
rating.
A functional, rated current power switch MUST be provided near the appliance in an
accessible position (AS/NZS 3000 - Clause 4.7.1).
Wiring must not be bent or compressed and must be protected against
mechanical failure (AS/NZS 3000 - Clause 3.9).
Disconnection in the fixed wiring must occur in accordance with the AS/NZS 3000 wiring
rules.
The oven MUST be properly earthed.
This oven must be connected with cable of 75°C rating minimum.
This product has passed the insulation resistance test after manufacture. If the resistance
reading is low at installation, it is probably caused by moisture from the atmosphere
being absorbed by the elements after the range has been produced. (pass at 0.01 M
AS/NZS 3000 Wiring Rules Clause 8.3.6.2).
Connecting to the mains services and commissioning
This appliance must be installed by a licensed electrician, according to all codes and
regulations of:
Electrical supply authorities.
Building regulations.
Local government and council authorities.
AS/NZS 5601.1 (particular attention to clause 6.10.1, including figure 6.3 and subclause
6.10.1.11).
AS/NZS 3000 (particular attention to clauses 4.7.1 and 3.9)
Loading ...
Loading ...
Loading ...